Skip to content

GATE TITAN V2 Basic Module (Front Wired)

Waardering 0 uit 5
(be the first to review)

84.95

Op voorraad

Artikelnummer: GATE_TTN2-BF Categorie: Merk:  

Beschrijving

TITAN™ (drop-in mosfet) will transform your AEG into an advanced training weapon system. Gain a tactical advantage thanks to the extremely fast trigger response, with an option of adjusting the AEG for each mission with 20 functions. Give your AEG a new lease of life!

TITAN gives you the option to adjust:

  • Trigger sensitivity
  • Pre-cocking boost
  • Fire selector mode
  • Burst mode
  • Rate of fire
  • Low battery warning
  • Battery protection
  • Sniper delay

TITAN has no less than eight sensors!

  • 1 gear sensor
  • 2 selector sensors
  • 5 trigger sensors

 

Thanks to the optical sensors we have eliminated the problem of faulty switches that can occur in competitors’ drop-in mosfets. The trigger has no mechanical connections with the PCB. This eliminates mechanical stresses and provides for high reliability.

GATE CTO, April 2016

  • Automatic BURST – there is no need to set burst time. You can set burst between two and 10 shots;
  • Automatic PRE-COCKING – Pre-cocking is fully operational in SEMI, BURST and AUTO mode and there is no need to set pre-cocking boost manually. You can easily set the pre-cocking as high, mid or low;
  • FULL CYCLE – when the precocking is off, TITAN ensures that the gearbox always makes full cycles.

You can trust TITAN because:

  • Every time you pull the trigger gearbox completes the correct cycle. The gears stop exactly where they should. The gearbox works efficiently.
  • It is protected against short-circuits, overheating and overloading
  • It protects the battery against over-discharge
  • It significantly improves battery life, rate of fire, spring life and gearbox reliability (when pre-cocking is off)
  • It is compatible with the strongest AEG replicas and batteries (ready to use with LiPo 14.8V, 5000 mAh, 60C)

Why TITAN is so special?

  • It has a user-friendly configuration via the Tactical Programming Card and/or GATE Control Station
  • It has option to make firmware updates via the internet
  • It has innovative optical sensors instead of mechanical switches that can be prone to faults
  • It replicates a trigger response like in a real gun
  • It replaces the cut-off lever
  • It is compatible with DSG and SSG gears
  • It is compatible with most v2 gearboxes (including cnc) on the market without any modification

Beoordelingen

Er zijn nog geen beoordelingen.

Leave a customer review

Je e-mailadres wordt niet gepubliceerd. Vereiste velden zijn gemarkeerd met *

Andere suggesties…

Back To Top